Manitowoc Ice QM30 Series Uživatelský manuál

QM30 Series Ice Machines Installation, Use and Care, Manual Thank you for selecting a Manitowoc Ice Machine, the dependability leader in ice

Installation Instructions Section 22-2 Location of Ice Machine The location selected for the ice machine must meet the following criteria. If any

Section 2 Installation Instructions2-3 Electrical Service WARNING All wiring must conform to local, state and national codes. Ice Machine Volt

Installation Instructions Section 22-4 THIS PAGE INTENTIONALLY LEFT BLANK

Section 2 Installation Instructions2-5 Water Service/Drains WATER SUPPLY Local water conditions may require treatment of the water to inhibit scal

Installation Instructions Section 22-6 ICE MAKING WATER INLET TUBING 0.95 cm (3/8”) MINIMUM INSIDE DIAMETERICE MAKING/BIN WATER DRAIN TUBING 1.59

Section 3 Ice Machine Operation3-1 Section 3 Ice Machine Operation Sequence of Operation Control Board Relays Ice Making Sequence of Operatio

Ice Machine Operation Section 33-2 Ice Thickness AdjustmentQM-30 dice ice cube formation is slightly different from our previous models. Manitowo

4-1 Section 4 MaintenanceSection 4 MaintenanceInterior Cleaning and SanitizingGENERAL You are responsible for maintaining the ice machine in accord

Maintenance 4-2 Section 4Step 4 Wait until water flows over the evaporator (about three minutes) then add the proper amount of Manitowoc Ice Machine

4-3 Section 4 MaintenanceParts Removal Overview WATER TROUGH OVERFLOW TUBE WATER DISTRIBUTION TUBE WATER PUMP AND BRACKET ASSEMB

Safety Notices When using or servicing these Ice Machines, be sure to pay close attention to the safety notices in this manual. Disregarding the notic

Maintenance 4-4 Section 4WATER PUMPPOWER CORD OUTLET B. Remove the Overflow Tube • To remove the tube, lift it up while using a slight back and fo

4-5 Section 4 MaintenanceStep 7 Mix a solution of cleaner and warm water. Depending on the amount of mineral buildup, a larger quantity of solution

Maintenance 4-6 Section 4 WARNING Disconnect electric power to the ice machine at the electric switch box before proceeding. Step 17 Repeat step 6

4-7 Section 4 MaintenanceCLEANING THE CONDENSER WARNING Disconnect electric power to the ice machine at the electric service switch before cleani

4-8 Maintenance Section 4Removal from Service/Winterization GENERAL Special precautions must be taken if the ice machine is to be removed from serv

Section 5 Before Calling for Service5-1 Section 5 Before Calling for Service Checklist If a problem arises during operation of your ice machine,

Before Calling for Service Section 55-2 Problem Possible Cause To Correct Ice machine produces shallow or incomplete cubes, or the ice fill patte

MANITOWOC ICE, INC. 2110 South 26th Street P.O. Box 1720 Manitowoc, WI 54221-1720 USA Phone: (920) 682-0161

Table of Contentsi Table of Contents Section 1 - General Information Model/Serial Number Location ...

Table of Contents ii THIS PAGE INTENTIONALLY LEFT BLANK

Section 1 General Information1-1 Section 1 General Information Model/Serial Number Location Record the model and serial number of your ice machin

General Information Section 11-2 Owner Warranty Registration CardGENERAL The packet containing this manual also includes warranty information. War

Section 1 General Information1-3 Residential Warranty Coverage WHAT DOES THIS LIMITED WARRANTY COVER? Subject to the exclusions and limitations b

1-4 General Information Section 1 INTENTIONALLY LEFT BLANK

Section 2 Installation Instructions2-1 Section 2 Installation Instructions 76.20 cm (30.00”) 56.74 cm(22.34”) 50.00 cm(19.6